Switch prevents unit operation in the event combustion products’ passage through the flueway is reduced or blocked.Ģ4 volt (40VA) control transformer is furnished as standard equipment and is factory installed on control panel. Manual reset switch is furnished as standard and is factory installed on the burner box. The cabinet surface temperatures are low due to foil faced fibreglass insulation on side and back panels of heat section. This spark is intermittent and occurs only when required.Ĭontrols all furnace operations and provides direct readout diagnostics for quick troubleshooting.Ĭonstructed of heavy gauge, cold rolled steel with a primed and pre-painted topcoat finish. Solid-state electronic direct spark ignition control provides positive and safe main burner ignition insuring reliable start every time the heater fires up. ![]() ![]() Blower compartment minimises losses and maximises efficiency and comfort. This compact design allows complete exposure of heating surfaces to supply air stream whilst reducing space requirements inside the heater cabinet.Įxceeds industry standard airflow for even temperatures and improved comfort. The gas valve on the ML180UH will be equipped with a gas control switch. When removing the front panel of the furnace, look for a raised switch or a button on the side of the control panel area. The panel's location will vary by furnace model, so you may find that the panel is on the side or bottom area of the furnace. ![]() Made out of patented Armour Tuf™ aluminised steel construction ensures superior resistance to corrosion and oxidation. COMBUSTION AIR INDUCER TOP CAP INTEGRATED CONTROL PRESSURE SWITCH BLOWER ACCESS PANEL UPPER ACCESS. Then lift the front panel off and set it to the side.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |